Skip links

MOP Module

Objective

 

To train marine engineers in the precision-heavy tasks of replacing electronic and hydraulic control components on Man B&W ME-C engines. By simulating these high-stakes procedures in VR, learners can practice delicate sensor alignments.

Topics Covered:

 

MPC (Multi-Purpose Controller) Replacement:
• Electrostatic discharge (ESD) safety protocols.
• Addressing communication failures and backing up software configurations.
• Hardware swap procedures.

FIVA (Fuel Injection Valve Actuation) Valve Replacement:
• Hydraulic System isolation and depressurization of the 300-bar rail.
• Disconnection of electrical feedback cables and high-pressure oil pipes.
• Safe lifting techniques for the valve block and ensuring O-ring integrity during seating.

Tacho System Alignment:
• Installation of the Angle Encoder/Tacho pickup sensors.
• Adjusting the physical clearance (air gap) between the sensor and the turning wheel.
• Fine-tuning the TDC (Top Dead Center) offset and verifying signal synchronization with the engine control system.

🍪 This website uses cookies to improve your web experience.